← Case Studies
Case Study June 2026

1200 x 1200mm 316L main control enclosure for an offshore crane maker

Large brushed stainless steel double-door enclosure with a display cut-out and pushbutton holes in the left door

A UK offshore crane specialist had a time-critical need for the main electrical enclosure on their latest crane. It had to cope with a salt-laden marine atmosphere and be ready for their panel builders to fit out.

The brief

  • 316L stainless steel, 1.5mm gauge, brushed finish, for corrosion resistance offshore
  • 1200mm high x 1200mm wide x 300mm deep: a scaled-up version of a unit we had built for them before
  • IP66
  • A revised door cut-out layout for new operator interface components

What we built

  • Left- and right-hand lift-off doors, each with a chrome L-handle and multi-point locking that stays closed under vibration
  • A removable centre bar for full access to the back panel when installing heavy equipment
  • Door stays on both doors for safe hands-free working
  • 10 x M6 x 25mm welded rear studs for the supplied galvanised mounting plate
  • An M10 internal/external earth stud for bonding to the vessel structure
  • Four welded bolt-on lugs for wall or bulkhead fixing
  • A removable bottom gland plate, so the customer can drill and gland it at ground level
  • Door cut-outs machined to the issued GA drawing

A repeat customer

The customer came back because the earlier, smaller enclosure had performed in service. Scaling the design up to 1200mm square while keeping IP66 sealing and a consistent brushed finish is typical of the bespoke work our factory is set up for.

Got a similar requirement? Send us your drawing or spec, or call +44 1233 801 890.

Get started

Ready to specify?
We'll quote it today.